VCON VIGO Installation And Setup Manual - page 30
Chapter 3 vPoint Setup
3–4
VCON ViGO Installation and Setup Guide
vPoint Installation Utility Window
3. Click Install vPoint to start the vPoint installation process.
4. A message then asks if your system will register to a VCON Media
Xchange Manager™ (MXM) system. If your system is managed by an
MXM, telephony exchange functions such as Call Forwarding, Call
Pickup, Call Transfer and Ad-hoc Conferencing are available.
MXM Management Question
Click Yes or No, accordingly, to continue. If asked if you are sure if you
want MXM management, click Yes again to install an MXM-managed
version.
5. The Welcome screen appears. Follow the instructions of the Setup Wizard.
To advance to each following page, click Next.
6. To start vPoint for the first time, you must restart the computer. Select Yes
if you want to restart the computer now or select No if you want to
continue with another activity and restart the computer later.
Click Finish and close the Installation program.
7. While the computer is restarting, turn the ViGO on. During its startup
process, the computer will detect the ViGO and install the necessary
drivers.