VCON VIGO Installation And Setup Manual - Oint
VCON ViGO Installation and Setup Guide
3–1
3
V
P
OINT
S
ETUP
Before connecting the ViGO system (with its accessories) to the computer, install
and set up the vPoint software. The vPoint setup stages include:
T
Verifying that your computer equipment matches the minimum requirements
T
Uninstalling any previous version of VCON videoconferencing application
(MeetingPoint)
T
Installing the new version of vPoint.
3.1
Minimum System Requirements
Before installing vPoint, make sure that your computer equipment meets the
following minimum requirements:
T
PC, notebook computer or laptop computer - Pentium II 350 MHz or higher
T
Any Ethernet Network Interface Card (for LAN/IP videoconferencing)
T
Windows 98/ME/2000/XP operating system with Microsoft TCP/IP installed
T
CD-ROM drive or access to a network CD-ROM drive
T
Universal Serial Bus (USB) installed
T
64 MB RAM (Windows 98/ME/2000)
128 MB RAM (Windows XP)
T
40 MB free disk space
T
Mouse or other pointing device
T
SVGA monitor or projector
T
SVGA card supporting Direct Draw with minimum 2 MB memory.