VCON VIGO Installation And Setup Manual - page 32
of
48
Chapter 3 vPoint Setup
3–6
VCON ViGO Installation and Setup Guide
3. Click Connect to complete the login process.
— If the MXM automatically registers your computer, the vPoint
application opens.
— If a message appears stating that the vPoint startup cannot proceed
until login is granted, contact your system administrator.
After login is granted, click Connect to continue. .
vPoint appears on the screen.
vPoint Main Viewer
At this point, if the system’s communication lines are connected, you may
start a videoconference and receive incoming video calls.
If you are running vPoint for the first time after installation, the vPoint Setup
appears. In this dialog box, enter the information required to run vPoint from
your specific location.