WEG CFW-11 User Manual - page 76
KEYPAD (HMI)
4
4-4 | CFW-11
Run
LOC
1800rpm
12:35
Menu
1800
rpm
1.0
A
60.0
Hz
Inverter status:
- Run
- Ready
- Config
- Self-tuning
- Last fault: FXXX
- Last alarm: AXXX
- DC braking
- STO
Motor speed direction
indication.
Loc./Rem. indication:
- LOC: Local situation.
- REM: Remote situation.
Motor speed indication
in rpm.
Monitoring parameters:
- Motor speed in rpm.
- Motor current in Amps.
- Output frequency in Hz (default).
P0205, P0206 and P0207: selection of
the parameters that will be displayed in the
monitoring mode.
P0208 to P0212: engineering unit for the speed
indication.
Right soft key function.
Hour indication.
Setting at:
P0197, P0198 and P0199.
Left soft key function.
(a) Monitoring screen with the factory default settings
Run
LOC
1800rpm
12:35
Menu
rpm
A
Hz
Monitoring parameters:
- Motor speed in rpm.
- Motor current in Amps.
- Output frequency in Hz (default).
P0205, P0206 and P0207: selection of the parameters
that will be displayed in the monitoring mode.
P0208 to P0212: engineering unit for the speed
indication.
100%
10%
100%
(b) Example of a monitoring screen with bar graphs
Run
LOC
1800rpm
12:35
Menu
1800
Value of one of the parameters defined in P0205,
P0206, or P0207 displayed with a larger font size.
Parameters not to be shown must be programmed with
0 in P0205, P0206 or P0207.
rpm
(c) Example of a monitoring screen displaying a parameter with a larger font size
Figure 4.3 - (a) to (c) - Keypad monitoring modes
4.2 PARAMETER STRUCTURE
When the right soft key ("MENU") is pressed in the monitoring mode, the display shows the first 4 groups of
parameters. An example of how the groups of parameters are organized is presented in
Table 4.1 on page
4-5
. The number and name of the groups may change depending on the firmware version used. For further
details on the existent groups for the used firmware version, refer to the programming manual.