Wood Stone WS-MH-RFG-IR Installation And Operation Manual - Mantle Mounting

Questions? Call Wood Stone at 800-578-6836

13

MH-RFG-IR  Installation and Operation Manual

September

2006

MANTLE MOUNTING

Whether mounting a stainless mantle or a bracket for a granite mantle,

the initial steps are the same.

2. Next, place two spacer

washers on each stud.

4. Finally, place one final

washer (stainless steel) and

a cap nut on each stud.

Tighten the cap nuts so that

the mantle is securely held

in place.

5. Using the high temperature silicone (provided), fill any gaps between the oven hearth and

the mantle flange. Gaps between the mantle flange and the stainless steel doorway frame

may also need to be filled with a small amount of the silicone compound.

INSTALLATION OF GRANITE - After completing the steps outlined above, apply a generous

amount of silicone adhesive (provided) to the top of the steel mantle bracket.

Put the stone in place and

apply light pressure to seat

it propery. Make sure that the

angle in the granite lines up

with the angle in the bracket.

Allow the adhesive to set for

several hours before filling

any gap between the stone

slab and the metal bracket

with the silicone compound

(provided). Clean up any

adhesive and/or silicone

before it dries!

1. Begin by installing the threaded studs into the

clip nuts below the oven doorway (3 or 4 turns is

sufficient).

3. Position the mantle (or bracket) on the oven,

making sure that the rear flange rests on the floor

of the oven (you may need an extra pair of hands

at this point).