Wood Stone WS-MH-RFG-IR Installation And Operation Manual - Unloading and Moving
Questions? Call Wood Stone at 800-578-6836
3
MH-RFG-IR Installation and Operation Manual
September
2006
LIFTING THE APPLIANCE
1. USING A CRANE
The appliance arrives with four lifting eyes at-
tached. When craning, use a spreader
bar with a two-legged sling rigged on each end.
The spreader bar should be of a sufficient length
to keep the sling from contacting the sides of the
appliance.
NOTE: Once lifting eyes are no longer
needed, remove the lifting eyes one at a time AND
BE SURE TO REPLACE THE BOLTS THAT AT-
TACH THE MAIN BODY TO THE STAND.
2. USING A FORKLIFT
USING A PALLET JACK TO MOVE THE APPLIANCE
Once the appliance has been removed from the delivery ve-
hicle, it can easily be moved on flat surfaces using a pallet
jack. To lift with a pallet jack, remove the front and rear angle
iron stabilizers from the base of the stand and place a stout
4x4 post through the fork pocket as shown. THE APPLIANCE
IS VERY TOP-HEAVY, MOVING THE APPLIANCE UP OR
DOWN A RAMP ON A PALLET JACK IS
NOT SAFE!
Contact Wood Stone if the appliance must be turned on its side for specific instructions. Moving a
Wood Stone oven can present interesting challenges to even the most experienced riggers.
Take your time, use your head, secure the proper equipment and make safety your first priority. Please
don’t hesitate to call the factory for technical support (1-800-578-6836).
DO NOT TURN THE APPLIANCE ON ITS SIDE!
Model # Oven Approx. Weight Req’d Forklift
WS-MS-4 Mt. Chuckanut
2,200 lbs. 5,000 lb.
WS-MS-5 Mt. Adams
3,300 lbs. 6,000 lb.
WS-MS-6 Mt. Baker
4,200 lbs. 6,000 lb.
WS-MS-7 Mt. Rainier
5,300 lbs. 9,000 lb.
DELIVERY NOTE:
The customer will receive a Shipping Notification when the unit leaves the Wood Stone factory. This
will include a PRO# and a trucking company contact number. Wood Stone recommends that you
confirm the delivery date/time with the trucking company before committing to heavy equipment and/
or labor. Our goal is a smooth and safe delivery. Thank you.
UNLOADING AND MOVING
LIFTING EYES
Be sure to use a forklift rated to lift more than the
appliance weighs as shown below. Fork length must
be at least 6 feet, if not, fork extensions should be
used. The stand is equipped with fork pockets just
above the angle iron base.
The appliance is very
top heavy so spread the forks as far apart as pos-
sible.
4x4 post