Wood Stone WS-MH-RFG-IR Installation And Operation Manual - Electrical
Questions? Call Wood Stone at 800-578-6836
9
MH-RFG-IR Installation and Operation Manual
September
2006
ELECTRICAL
Have a licensed electrician wire the transformer terminal strip with a
120V, 15 amp lead. Electrical diagrams are located directly to the right, behind
the removable service/intake panel of the appliance as well as inside the control
box and also on page 24 of this manual. Also, see the figure on page 14 of this
manual for location of the transformer enclosure.
Electrical Code Limitations
ELECTRICAL GROUNDING: This appliance must be electrically grounded in accordance
with local codes, or in the absence of local codes, with the National Electrical code, ANSI/
NFPA 70 or the Canadian Electrical Code, CSA C22.1 as applicable.
WARNING FOR APPLIANCES EQUIPPED WITH A POWER CORD: If this appliance was
provided with a cord, the cord is equipped with a 3 prong grounding plug for your protection
against shock hazard and should be plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from the plug.