Wood Stone WS-MH-RFG-IR Installation And Operation Manual - page 23
Questions? Call Wood Stone at 800-578-6836
23
MH-RFG-IR Installation and Operation Manual
September
2006
Quick Troubleshooting Guide
Problem Solution
Controller will not turn on.
1.Incoming power turned off. Check circuit
breaker for circuit supplying the appliance.
Check that any wall switches external to the
appliance that control incoming power are
turned on. Check that any interlocks external to
the oven are turned on.
2. If control still does not turn on, please
contact Wood Stone for assistance.
Radiant flame does not
light.
1. Is gas turned on to the appliance? Is incoming
gas valve turned all the way on?
2. Debris in burner. Burner may require cleaning.
Contact Wood Stone for assistance.
3. Damaged igniter or gas valve. Contact Wood
Stone for assistance.
First time start up:
Has all air been bled from the gas line?
Are the switches onthe SV-1 and SV-2 valves
beneath the oven in the ON position?
Underfloor burner is not
running.'Hearth Heat' light
is off.
Hearth temperature is
above the setpoint.
'Chec' display on
controller.
Underfloor burner did not fire when the floor
temperature dropped below the setpoint.
Contact Wood Stone for assistance.
Please contact Wood Stone at 1-800-578-6836 should service be
necessary, or if you have any questions about the appliance. Our office
hours are 8am to 4:30pm West Coast time.
TROUBLESHOOTING
Hearth temperature is above the setpoint.
This is normal. Radiant (dome) flame can
drive the temperaure over the setpoint. The
setpoint only controls the underfloor (hearth)
burner.Turn down the dome flame if needed.