Zebra CPCL Programming Manual - Printer Commands

Mobile Printer CPCLProgramming Manual

P2-1

PRINTER COMMANDS

A label file always begins with the “!” character followed by

an “x” offset parameter, “x” and “y” axis resolutions, a label

length and finally a quantity of labels to print.  The line con-

taining these parameters is referred to as the Command

Start Line.

A  label file always begins with the Command Start Line

and ends with the “PRINT” command.  The commands that

build specific labels are placed between these two com-

mands.

A space character is used to delimit each field in a com-

mand line.

Note: Every line in the command session must be terminated with both

carriage-return and line-feed characters.  All Printer Commands must be in

uppercase characters ONLY.