Zebra CPCL Programming Manual - Wireless Network Printers

Mobile Printer CPCLProgramming Manual

P12-1

WIRELESS NETWORK PRINTERS

Introduction

Zebra Cameo 3N and Encore 3N Network Printers are

equipped with a WLAN (Wireless Local Area Network)

card.  Network printers allow wireless communication as

a node within a local area network, and its wireless capa-

bilities allow communications from any point within the

LAN’s perimeter.

The following section details commands used with Net-

work Printers to configure various characteristics and to

interrogate the printer for its network settings.

Note: If you are using a WLAN enabled QL series

printer, you should use the “get, set,do” parameters

detailed in Section 14 rather than the LAN command

detailed below.

Network Printer Safety Considerations

WARNING: Use of the Network Printers will result in

exposure to Radio Frequency radiation. To conform to

FCC RF exposure requirements these printers must be

used only in the intended orientation and in the in-

tended manner.

Refer to the User’s Manual for the Network Printer in use

for more specific safety instructions.  In all cases, avoid

prolonged exposure closer than 5 cm. (2 in.) to the radiat-

ing area around this unit’s antenna.

LAN Command

Format:

LAN 

{ Operation } { Options }…{ Operation } { Options }

The LAN command can be used to interrogate and con-

figure the Wireless LAN (WLAN) card in a Zebra Network

Printer. The entire LAN command must be terminated by

a CRLF pair (0x0D0x0A).