Zebra CPCL Programming Manual - page 218

P12-4

Mobile Printer CPCLProgramming Manual

following form:

LAN Status report:

ipAdr = nnn.nnn.nnn.nnn

userName = {the user name}

fwVersion = {LAN firmware version}

swVersion = {LAN software version}

MAC addr = hh:hh:hh:hh:hh:hh

associated = {link state}

Where:

nnn.nnn.nnn.nnn

 = a typical TCP/IP address.

{the user name}

 = a descriptive username set in the

radio.

{LAN firmware version}

 = a descriptive firmware ver-

sion set in the radio.

{LAN software version}

 = a descriptive software ver-

sion set in the radio.

hh:hh:hh:hh:hh:hh

 = the IEEE network address of the

LAN card.

{link state}

 = YES or NO

Syntax: GET-STATUS 

{option}

Where 

{option}

= PRINT or REPLY.

Example: ! U1 LAN GET-STATUS PRINT

GET-CONFIG – This operation causes the printer to

report its current WLAN configuration. The two op-

tions are PRINT and REPLY.  If PRINT is used, the

configuration dump is printed. If REPLY is used, the

configuration dump is sent out over the CABLE. The

configuration report is of the following form:

LAN Config report:

ipAdr = nnn.nnn.nnn.nnn

powerMode = {power mode state}

quiet = {quiet state}

protocol = {protocol selected}

essID = {SSID string}

DHCP = {DHCP state}

DHCP_SAVE = {DHCP_SAVE state}