Zebra CPCL Programming Manual - Ip.Snmp.Create_Mib
P14-58
Mobile Printer CPCLProgramming Manual
ip.snmp.create_mib
type: do
This parameter refers to creating a file of the printer’s
MIB.
do parameters
Filename (NOTE: The filename is up to eight
characters in length with a three-character exten-
sion. )
Example
Description
This command instructs the
printer to create an SNMP MIB file
based in the current set/get param-
eters in the printer’s application.
The file will be stored on the
printer’s file system with the
filename supplied as the parameter
in the do command. The MIB file
can then be retrieved (via Label
Vista, FTP, or other wired / wireless
connection to the printer) and
passed onto any SNMP-based util-
ity to provide a means to monitor
and configure all the printer’s pa-
rameters via SNMP.
Syntax
! U1 do “ip.snmp.create_mib”
“EXAMPLE1.MIB”
Result
EXAMPLE1.MIB will be created in
the printer’s file system with the
printer MIB information stored in it.
ip.tcp.enable
type: getvar; setvar
This parameter refers to the TCP socket protocol.
getvar result
Returns the TCP protocol status. (on or off)
Example
Description
Instructs the printer to respond with
the TCP setting.
Syntax
! U1 getvar “ip.tcp.enable”
Result
“on”
setvar choices
“on”, “off”
Default
“on”
Example
Description
Instructs the printer to enable the
TCP protocol.
Syntax
! U1 setvar “ip.tcp.enable” “on”
Result
The TCP protocol will be turned on
upon cycling the power or issuing
device.reset.