3Com CoreBuilder 9000 Command Reference Manual - page 160
160
C
HAPTER
5: O
UT
-O
F
-B
AND
M
ANAGEMENT
management ip route
✓
3500
9000
9400
3900
9300
display
Displays the system’s routing table to determine which routes to other IP
networks are configured and whether the routes are operational.
Valid Minimum Abbreviation
m ip ro di
Important Considerations
■
The system prompts you for an IP address and subnet mask. This
information enables you to display only a subset of routes instead of
all routes. To see all entries in the table, press Return at the prompts.
■
The first line in the output (the status line) indicates whether IP routing
is enabled (in-band only):
■
IP interface options (such as ICMP router discovery) appear under
ip interface detail
and are set on a per-interface basis.
■
The route table display includes a range for the routing table entries as
follows:
There are
n of m possible Routing Table entries.
Where n is the minimum and m is the maximum number of entries.
Options
Prompt
Description
Possible Values
[Default]
IP address
IP address that
directs the system to
display only those
routes that match
the bits set in the
specified IP address
(and its
corresponding
subnet mask)
Press Enter to take
the default, which
displays all entries
A valid IP address
0.0.0.0
Subnet mask
Subnet mask that
directs the system to
display only those
routes that match
the bits set in the
subnet mask for the
specified IP address
A valid subnet mask
Based on
specified IP
address