3Com CoreBuilder 9000 Command Reference Manual - page 89
system softwareUpdate
89
system
✓
3500
9000
✓
9400
✓
3900
✓
9300
softwareUpdate
Loads a new revision of system software.
Valid Minimum Abbreviation
sy so
Important Considerations
■
The CoreBuilder 3500 uses the Trivial File Transfer Protocol (TFTP) or
File Transfer Protocol (FTP) to transfer the files to the host, depending
on the setting for the
system fileTransfer
option. The SuperStack II
Switch 3900, Switch 9300, and the CoreBuilder 9400 use TFTP to
transfer files.
■
Before you attempt to install the system software, make sure that you
have extended memory installed on your system.
■
You can load the system software into flash memory while the system
is operating. The system does not have to be powered down.
■
Make sure that the FTP server or TFTP server software is running on the
device from which you are installing the software.
■
Make sure that you have defined an IP address on your system.
■
Some FTP servers or TFTP servers do not accept the full pathname. If
this is true on your server, enter the image filename only.
■
On the CoreBuilder 3500, if you are using the FTP file transfer
protocol, you must enter a login name and password.
Options
Prompt
Description
Possible Values
[Default]
Host IP
address
IP address of the machine from
which to load the software
update
Any valid IP address –
Install file
name
Name of the image to be
loaded
–
–