3Com CoreBuilder 9000 Command Reference Manual - page 722
722
C
HAPTER
22: Q
UALITY
OF
S
ERVICE
(Q
O
S)
AND
RSVP
f
Specify the bridge ports for which you want to enable the new rate
limit (for example,
1-13
, or
all
).
If you modify the rate limit and apply it to only one or a subset of the
bridge ports, you are prompted to specify whether you want to
modify or define another rate limit for another set of bridge ports. If
you specify
yes
, you are prompted to enter another rate limit and
burst size. This sequence of prompting continues until you specify
n
,
meaning that you do not want to modify or define another rate limit
for another set of ports. The rate limit applies only to those ports that
you explicitly specified; any ports that you did not specify are not
associated with your rate limit.
7 Select an IEEE 802.1p tag value in the range of from
0
through
7
or the
value
none
to apply to forwarded frames.
8 Specify whether drop packets are used to establish a TCP connection
(
yes,
no
). The default is
no
.
9 Set the start and end time for the control (
yes, no
). The default is
no
.
a If you specified a start and end time, enter the time type.
Time type selections are variations on days of the week and weekends
or it can be specific day (or range of days) and time. See Table 7 for a
complete listing of input time type options.
b Enter the starting day and/or time.
c Enter the ending day and/or time.
10 Enter the classifiers that are subject to this control. The system displays
the associated classifiers in brackets. (If you select
aggregate
as the rate
limit type, or select the drop packets use to establish a TCP connection
option, the system displays only flow classifiers.)