B&G Triton Display Installation Manual - 14 |
14 |
Installation |
B&G Triton Display Installation Manual
Fitting with retention bracket
The Triton display may be mounted using only the mounting clip, or
may be secured additionally with the retention bracket. In order to
secure the bracket, adequate rear access must be available to fit the
fasteners.
Before fitting the display in to the mounting position, firmly wind
the threaded rods into the back of the Triton display by hand.
Place the display in to position and fit the retention bracket,
followed by washers and fasteners.
Multiple displays
If mounting Triton displays in a row or column, ensure that enough
space is left for the sun covers to clip on.
Even where the sun covers are not required, the correct spacing
should be used, as the displays require 3.5mm on each side when
rotating for removal from the mounting clip.
The absolute minimum space that should be allowed for each
display is:
•
Width:123mm(4.84”)
•
Height:120mm(4.72”)