B&G Triton Display Installation Manual - | 29

| 29

Display | 

B&G Triton Display Installation Manual

DRAFT COPY

Selecting a device from the list will show you an information pane 

with details of that device.

SomedevicessuchasanRC42compassstoretheirconfiguration,

calibration and offset data in their own memory and not in the 

display memory. For devices of this type you can check the data 

information, configure and calibrate the device by selecting 

Options.

Data

The data list shows the data type that the device is transmitting. 

Configure

Instance

Enter a number to differentiate between instances of the same 

device.

Offset

Certain devices will let you enter an offset value to compensate for 

the position of the sensor or variation of sensor data.

¼

Note: 

Some devices can be configured further. If a device transmits 

other data it may be shown on this page also.

Calibrate

For compass sensors only, once installed you will need to calibrate 

the device. Select Calibrate and follow the instructions on the 

display. See calibration section of the manual for more information.