B&G Triton Display Installation Manual - | 17
| 17
Wiring |
B&G Triton Display Installation Manual
DRAFT COPY
Power the network
An NMEA 2000 network requires its own 12 V DC power supply
protected by a 5 amp fuse or breaker.
In smaller NMEA 2000 systems, the power connection may be made
anywhere in the system,
For larger systems introduce power at a central point in the
backboneto“balance”thevoltagedropofthenetwork.Useapower
cable without termination.
¼
Note:
When joining an NMEA 2000 network to a SimNet network, it
is not necessary to introduce power to both.
¼
Note:
Do not connect the power cable to the same terminals as the
autopilot computer, pulse radar, bow thruster or other high current
devices-thenetworkmaybeaffectedbyvoltagedropwhenthese
devices are operated. Avoid connection to the engine starting
batteries where possible.
Daisy chaining the Triton display
Where displays are located close together, the supplied right angle
Micro-Ccablemaybeusedtolinkthedisplaysinseries.Thedaisy
chain should form part of the back bone. It is not advisable to daisy
chain devices off a drop cable.
LTW
LTW
2
LTW
LTW
2
1
3
1
1
3
1.
Triton Display
2.
RightangleMicro-Cplugconnectorcable0.4m(supplied)
3.
NMEA2000 / SimNet backbone