B&G Triton Display Installation Manual - | 27

| 27

Display | 

B&G Triton Display Installation Manual

DRAFT COPY

Sources

A data source can be a sensor or a device connected to the 

NMEA2000 network, providing information and commands to other 

networked devices. The data sources are normally configured at first 

time turn on. 

It should only be necessary to update this data if a new source is 

added, source is missing (sensor failure), source has been enabled/

disabled, sensor replaced or a network reset.

Auto select

The Auto select option will look for all sources connected to the 

instrument system. If more than one source is available for each 

item, the display will automatically select from the internal device 

priority list. 

1. 

Verify that all interfaced units are powered on

2. 

Pressthe‘Enter’keytostarttheautoselectprocedure