B&G Triton Display Installation Manual - 30 |
30 |
Calibration |
B&G Triton Display Installation Manual
Calibration
Depth
A typical transducer installation is through the hull in front of the
keel. A datum (offset value) can be set, such that the depth display
refers to either the water line or the base of the keel.
+VE: Positive Datum for Waterline
- VE: Negative Datum for Keel
(0.0)
Setting the depth offset displays depth readings from directly below
the keel or propellers of the boat, or from the waterline to the
seabed. This makes it easier to see the available depth, taking into
account the draught of the boat.
The offset value to be entered should represent the distance
between the face of the depth transducer, and the lowest part of
the boat below the waterline, or the distance between the face of
the depth transducer and the water surface.