B&G Triton Display Installation Manual - 38 |

38 | 

Autopilot | 

B&G Triton Display Installation Manual

Autopilot

IfanAC12orAC42

autopilot computer is connected to a Triton 

display and AP controller, autopilot control and setup functionality 

will be made available. 

 Warning: The installation settings must be performed as 

part of the commissioning of the Pilot system. Failure to do so 

correctly may prohibit the Pilot from functioning properly! The 

Installation menu can only be accessed in Standby mode.

¼

Note: 

Some important points regarding the installation settings:

When the Pilot is delivered from factory and ANY TIME AFTER AN 

AUTOPILOT RESET HAS BEEN PERFORMED, the installation settings 

are all reset to factory preset (default) values. The automatic 

interface prompt will appear and a complete setup has to be made.

The Sea trial settings are dependent on successful completion of 

the Dockside settings.

¼

Note: 

If you select the Pilot page and the Pilot has not been 

commissioned you can go straight to the commissioning page by 

selecting Setup.