Baltmotors ATV200-D Owner's Manual - page 23
Fittings and Fastenerns
Always check the tightness of chassis fittings
and fasteners before a ride.Refer to the Service .
Manual for correct tightening torque.
Lights
Check the headlight and taillight to make sure
they are in working condition. Repair as necessary
for proper operation.
Switches
Check the Operation of the headlight switch,
engine stop switch and any other switches.Repair
as necessary for proper operation.
Battery
.The battery is an enclosed one and unneces-
sary to fill water(see page)
.Don’t take off the closing bolt when charging.
.When charging,please obey the charging cur-
rent and time as shown on the following table.
Charge criteria:Charge the battery with ten per-
cent of capacity of battery for 5 to 10hours,or quickly
charge the battery with 2A to 3A for 2 hours.
Tire
The size and type (in low pressure condition) of
hollow tire used for ATV200-D are listed below.
Size
Front wheel
AT23
× 7-10
Rear wheel
AT22
× 10-10
warning
Use of improper tires on this ATV,or operation
of this ATV with improper tire pressure may increase
your risk of accident.
Use of improper tires on this ATV,or operation
of this ATV with improper tire pressure may cause
loss of control.
Pay attention to choose the Size and type of
used tire according to the description in the above
chart and make sure that the tire pressure is normal.
2.The tires should be set to the recommended
pressure.
Front 20KPa(0.20kgf/cm
2
2,2.8pai)
Rear 25KPa(0.25kgf/cm
2
2,3.6pai)
Check and adjust tire presssure when the tires
are cold.
Tire Pressure below the minimum specified
could cause the tire to dislodge from the rim under
severe riding conditions,the following are minimums:
Front 17KPa(0.17kgf/cm
2
)
Rear 22KPa(0.22kgf/cm
2
)
Higher pressures may cause the tires to burst.
Inflation could cause the tires to burst.
How to measure tire pressure
-12-