Baltmotors ATV200-D Owner's Manual - page 47
Manual is about: ATV200-D
of
58
2.Brake lever
a.Loosen the locknut and fully turn in the ad-
justing nut on the handlebar.
b.Turn in the adjusting nut on brake cable to get
a gap of 0-1mm between the lever and pin of pivot.
After maintaining ,pay attention to:
Make sure the brakes operate smoothly and
the free play is correct.
Make sure the brakes do not skid.
Replacement of brake components requires
professional knowledge.These procedures should
be done by our Group dealer.
Clutch adjustment
1.Loosen the lock nut
2.Slowly rotate the adjusting bolt counterclock-
wise until resistance is felt then,rotate it by1/8 turn
clockwise,i.e.45
o
.
-36-
a.20-30mm
↓
↑
a
1.Locknut 2.Adjusting nut a.5-7mm
① ②
@