Baltmotors ATV200-D Owner's Manual - Operation
OPERATION
WARNING
Never operate ATV until you are familiar with all controls.
Read the operation Manual carefully. If there is a controls or function you do not understand ,ask your our
dealer.
WARNING
Never ride the ATV in cold weather,always make sure all control cables work smoothly before you begin
ridding.Please read the engine brake-in section before you operate the engine at first time.
Starting a cold engine:
1.set the parking brake.
2.Turn the fuel lock to “ON”and the engine stop switch to “ ”.
4.Shift the transmission into neutral.
WARNING
The engine can be started in any gear if the rear brake lever is applier. However,it is recommended to shift
into neutral before starting the engine.
5.use the starter(choke)in reference to the figure.
NOTE
If the engine fails to start,release the start switch,then push the start switch again,pause a several
secords before the next attempt.Each cranking should be as short as possible to preserve battery energy.Do
not crank the engine more than 10 secords for each starting.
If the battery is discharged. pull the recoil starer to start ergine.
Starting a warm engine
The throttle should be opened slightly when starting a warm engine.
Prewarming
To get maximum engine service life,prewarm.the engine before startting off.Never accelerate forcefully
with a cold engine.
-14-