Baltmotors ATV200-D Owner's Manual - page 53
at places.
5.After cleaning ATV with clean water,immedi-
ately dry all surfaces with a chamois ,clean towel or
soft absorbent cloth.
6.Clean the seat with a vinyl upholstery cleaner
to keep the cover pliable and glossy.
7.Apply automotive type wax to all chrome plated
surfaces.Avoid use combination cleaner -waxes.Af-
ter using abrasives to protect scratched surface,let
the engine idle for several minutes.
After washing the brakes,let engine brake sev-
eral times at slow speeds to dry the linings.
B.Storage
Long term storage(60 days or more) of your ATV
will require some protective procedures to prevent
ATV from damage. After thoroughly cleaning the ATV,
adopt the following protective measures:
1.Add fresh fuel into fuel tank.
2.Add one tablespoon of SAE 10W30 or 20W40
motor oil in the spark plug.Ground the spark plug
wire and run the engine over several times to coat
the cylinder body with oil.
3.Lubricate all control cables.
4.Elevate the engine body to raise all wheels off
the ground.
5.Seal with plastic bag over the exhaust pipe
outlet to prevent moisture from entering.
6 . If st o ring AT V in a h um id or salt- air
atmosphere,cover all exposed metal surfaces with
a light plastic film of oil .Do not apply oil to any plastic
parts or the seat cover.
7.Take out the battery and store it in a dry place.
The battery should be stored in the place where the
ambient temperatrue should be 30℃ maximum and
0℃ minimum.
-42-