Baltmotors ATV200-D Owner's Manual - page 27
CAUTION
Do not coast for long periods with the engine
off, and do not tow the machine a long distance.
Even when gears are in neutral, the transmission is
only.Properly lubricated when the engine is running.
I n a d e q u a t e l u b r i c a t i o n m a y d a m a g e t h e
trarsmission.
To start and accelerate:
1.Release the throttle lever.
CAUTION
Always close the throttle while shifting gears.
Oth erwise,the engine and drive train may be
damaged.
2.Shift into first gear and release the shift pedal.
3.Open the throttle gradually once the machine
has obtained adequate speed.release the throttle
lever.
4.Shift into second gear and release the shift
pedal.
5.Open the throttle gradually,Follow the same
procedure.W hen shifting to the next higher gear.
To clecelerate:
W hen slowing down or stopping, release the
throttle and apply the brakes smoothly and even.As
you slow down,shift to a lower gear,Be sure that the
engine has sufficiently slowed before engaging a
lowe gear.Improper use of the brakes or control can
cause the tires to lose traction,reducing control and
increasing the possibillity of an accident.
Engine break-in
There is never a more important period in the
left of your machine than the period between zero
and 20 hours .During this period prolonged full
throttle operation or any condition which might result
in excessive engine heating must be avoided,after
every full throttle acceleration,the engine should run
at lower speed for a rest so as to rid itself of the
temporary build up of heat.If any abnormality is found
during this period ,consult a our dealer.
1.0-10 hours:
Avoid continuous operaton above half throttle.A
allow a cooling off period of five to ten minutes after
every hour of operation.Vary the speed of the ma-
chine from time to time.Do not operate it at one set
throttle position.
2.10-20 hours:
Avoid prolonged operation above 3/4throttle re-
volving the machine can freely through the gears
during running of engine but do not use full throttle
any time.
3 After break-in
Avoid prolonged full throttle operation.change
speeds occasionally.
Parking
W hen parking.Stop the engine and shift into
neutral.Turn the fuel to “OFF” and apply the parking
brake.
-16-