Baltmotors ATV200-D Owner's Manual - page 39
-28-
2. Engine oil replacement and oil fitter element
cleaning
a.Place the machine in a flat suface,W arm up
the engine for several minutes and turn off place a
container under the engine.Remove the dipstick and
open the drain plug to drain the oil.
b.Remove the oil fiter cover and oil filter,clean
the oil strainer and oil filter with solvent.
c.Inspect the O-ring and replace if damaged.
d.Reinstall the oil filter,O-ring and oil filter cover.
Replace the oil strainer,compression spring,O-ring
and drain pulg .Then tighten the drain plug and filter
cover bolts to the specified torque.
Tightening torque:
Drain pulg(engine):
43Nm(4.3m.kg)
Filer cover bolt:
10Nm(1.0m.kg)
e.Add oil to the engine with oil and install the
dipstick.
CAUTION
B e s u re n o f or eign m at er ial en t er s th e
crankcase.
f.W arm up the engine for several minutes at
idle speed.Check for oil leakage when warming up.
CAUTION
If oil leakage is found ,turn off the engine
promptly and check for the cause.
Recommended oil :see page 11
Oil quantity:
Periodic oil change:
1.5L(1.3mp qt)
W ith oil filter replacement:
1.6L(1.4mp qt)
Total amout:
1.8L(1.6mp qt)
①
1.oil gallery bolt