Calculated Industries 6260 User Manual - Getting Started

GETTING STARTED

Once assembly and setup are complete, proceed with the following steps in 

order to begin measuring.

1. When placing the bars and securing the drawing, make sure that the 

bars are at least 1" from the outermost measurements.

2. It is essential that the bars remain fi xed relative to the drawing’s 

position. Scribe a line to mark the initial location of the bars as a 

reference point should the bars shift.

3. The Puck should maintain a 45° angle within the bars while measuring.

4. Ensure that the measuring surface is fl at and smooth. Make sure there 

are no folds, tears, or raised areas of the plans.

5. Make sure there are no objects between the Puck and the bars. This 

includes hands, arms, pencils or pens, USB cable, cups, scale rulers, etc.

6. Make sure that no air current is blowing directly into the measuring 

area. Air blowing into the measuring path can result in no 

measurement reading. 

7. To get accurate measurements, make sure that the Puck and the bars are 

close to the ambient temperature of the work environment.

8 — U

LTRA 

S

CALE 

M

ASTER

®

P

RO