Calculated Industries 6260 User Manual - Digitizer Mode

DIGITIZER MODE

The Ultra Scale Master Pro can be used as a Digitizer to send measurement data (X,Y coordinates) and key press data to digitizing 

software on a host personal computer (PC). See PC Interface section for system requirements and USB connection information.

Press the [DIGITIZER] key to enter Digitizer Mode. Display will show “digi On.” It will remain in Digitizer Mode until the 

[DIGITIZER]

 key is pressed again, or when a manual reset is performed (see Reset section). 

WHILE IN DIGITIZER MODE:

The following keys send measurement data (X,Y coordinates) and key press data:  

[MEASURE] 

[END] 

[CLOSE –] 

[CLOSE +]  

The following keys send only the key press data:  

[UNDO]

 D-Pad 

Up 

[5] 

[PC SEND] 

[MODE] 

[HEIGHT]

D-Pad Down [6] 

[ARC/CIRC] [SCALE] [PREFS]

[M+]

D-Pad Right [4] 

[MR]  

[UNITS]

D-Pad Left [3] 

The following keys send no data: 

[ON/CLEAR] 

[SET]

[DIGITIZER]

U

SER’S 

G

UIDE

 — 41