Calculated Industries 6260 User Manual - page 48

5. PC SEND TERMINATING COMMAND:

Enter*

  –  Performs an ENTER command after value is sent to the PC.

Tab

–  Performs a TAB command after value is sent to the PC.

Left

–  Performs a LEFT command after value is sent to the PC.

Right

  –  Performs a RIGHT command after value is sent to the PC.

Up

–  Performs an UP command after value is sent to the PC.

Dn

–  Performs a DOWN command after value is sent to the PC.

None

  –  Performs no action after value is sent o the PC.

6. DIGITIZER OPERATION ORIENTATION:

Right*  –  Sets to right-hand operation orientation while in 

Digitizer Mode. See Right-Hand Assembly section.

Left 

–  Sets to left-hand operation orientation while in Digitizer 

Mode. See Left-Hand Assembly section.

7. USB SEND DELAY:

Delay 1*

– 

FASTEST USB send speed.

Delay 2

– 

MEDIUM USB send speed.

Delay 3

– 

SLOW USB send speed.

Delay 4

– 

SLOWEST USB send speed.

Use this setting to reduce the USB send speed if using a slower 

computer and experiencing problems sending values.

*An asterisk denotes a default value.

46 — U

LTRA 

S

CALE 

M

ASTER

®

P

RO