Calculated Industries 6260 User Manual - Units of Measurement

UNITS OF MEASUREMENT

The following units of measurement are available for selection by pressing the [UNITS] key located under the slide cover 

door. You may change the units of measurement of a displayed value at anytime during measuring, or after a measurement 

has been completed. All of the Linear, Area, and Volume units shown below are available in both Imperial and Metric modes 

and are displayed in the order shown beginning with the default. The Imperial/Metric switch (located on the back of the Puck) 

determines the default starting unit:

Note: You may change units on any displayed value, even while measuring. Continuous presses of [UNITS] will scroll through the available 

units of measurement listed above, converting the displayed value.  If the value is too large to be displayed in the units selected, the display 

will remain unchanged (maintaining the same value and units) until the value is converted to a unit that can be displayed.

LINEAR UNITS

Feet-Inch (FEET INCH)*

Feet (FEET)

Yards (YD)

Meters (M)**

Centimeters (CM)

Millimeters (MM)

Inch (INCH)

AREA UNITS

Square Feet (SQ FEET)*

Square Yards (SQ YD)

Acres (AC)

Square Meters (SQ M)**

Square Centimeters (SQ CM)

Square Millimeters (SQ MM)

Hectares (HA)

Square Inches (SQ INCH)

VOLUME UNITS

Cubic Yards (CU YD)*

Cubic Feet (CU FEET)

Cubic Meters (CU M)**

Cubic Centimeters (CU CM)

Cubic Millimeters (CU MM)

Cubic Inches (CU INCH)

*Imperial Default

**Metric Default

Note: If a measurement or calculation with small units of measurement 

exceeds the seven-digit range of the display, it will be automatically 

displayed in the next larger units (e.g. 20,000,000 millimeters is 

displayed as 20,000.00 m).

40 — U

LTRA 

S

CALE 

M

ASTER

®

P

RO