Calculated Industries 6260 User Manual - Custom Scales

There are two methods for programming Custom Scales 

into your Ultra Scale Master Pro. “Measured Custom Scales” 

allow you to measure a specifi ed Length and assign the 

known value. “Entered Custom Scales” allow you to enter 

and set a known scale that is not included within the 

available built-in scales of the Ultra Scale Master Pro.

Four Custom Scales can be stored in Imperial and Metric 

Modes for a total of eight Custom Scales. Once a Custom 

Scale has been set in either mode, it is retained until a new 

scale is stored in its place or until an All Clear or Reset is 

performed. Switching between Imperial and Metric Modes 

does not clear stored Custom Scales.

SETTING A MEASURED CUSTOM SCALE

CUSTOM SCALES 

1. Press [MODE] until “CUST” is displayed. Press [SCALE] 

to scroll through the four available custom scales. For this 

example, Custom Scale-1 is used.

2. Press [SET] then [SCALE] to begin setting the Custom 

Scale. The display prompts you to enter Point-1.

3. Place the crosshairs over the start point of the line and 

press [MEASURE]. You are prompted to enter Point-2.

4. Place the crosshairs over the end point and press 

[MEASURE]

. The display shows “0,000-00” for Imperial 

Mode and “00,000.0” is displayed for Metric Mode.

36 — U

LTRA 

S

CALE 

M

ASTER

®

P

RO