Calculated Industries 6260 User Manual - Built-In Scales

BUILT-IN SCALES

The following modes and scales 

are available for selection using 

the [MODE] and [SCALE] keys, 

depending on whether the puck 

is set to Imperial or Metric mode 

using the [IMP/MET] switch 

located on the back of the puck. 

While in Imperial Mode, only the 

Imperial Modes and Scales are 

displayed. While in Metric Mode, 

only Metric Modes and Scales are 

displayed. However, all Imperial 

and Metric units of measurement 

are available within both modes. 

When switching back and forth 

between Imperial and Metric 

modes, your settings within 

each mode are held, including 

Preference. The values stored in 

[HEIGHT]

 and [M+] are cleared 

when switching between Imperial 

and Metric modes.

Note: While in Metric Mode, MET 

will appear in the scale area of 

the display to indicate that it is in 

Metric Mode.

IMPERIAL

Modes Scales

Architectural (ARCH)

1 Foot =

Engineering I (ENGI)

1 Inch =

Engineering II (ENGII)

1 Inch =

1/4," 3/8," 1/2," 3/4," 1/1" (1"), 3/2" (1-1/2"), 2/1" (2"), 

3/1" (3"), 4/1" (4"), 1/32," 1/16," 3/32," 1/8," 3/16"

10.0,' 20.0,' 30.0,' 40.0,' 50.0,' 60.0,' 83.3,' 100.0,' 166.6,' 

200.0,' 250.0'

300.0,' 333.3,' 400.0,' 416.6,' 500.0,' 583.3,' 600.0,' 625.0,' 

666.6,' 750.0,' 1,000,' 1,200,' 2,000,' 3,000'

METRIC

Modes Scales

Architectural

(MET ARCH)

Engineering I

(MET ENGI)

Engineering II

(MET ENGII)

1:50, 1:75, 1:1, 1:2, 1:3, 1:4, 1:5, 1:10, 1:20, 1:25, 1:30, 1:40

1:100, 1:125, 1:150, 1:200, 1:250, 1:300, 1:400, 1:500

1:1000, 1:1250, 1:1500, 1:1625, 1:2000, 1:2500, 1:5000, 

1:6000, 1:10k, 1:12.5k, 1:20k, 1:25k, 1:50k

Note: The default Modes and Scales are listed fi rst and the remaining Modes and Scales 

are listed in the order that they appear on your Ultra Scale Master Pro.

U

SER’S 

G

UIDE

 — 17