Calculated Industries 6260 User Manual - Setting A Height

A Height can be set to calculate Wall Areas and Volumes which are displayed using the D-Pad once an area measurement has 

been completed. If no Height is stored, Wall Area and Volume are not displayed. The following example is shown in Imperial 

Mode. The displays will be slightly different if in Metric Mode.

SETTING A HEIGHT

1. Press [SET] then [HEIGHT] to begin entering a Height.

2. The displayed units begin fl ashing, indicating that they 

are ready to be changed. Press [UNITS] to scroll through 

the available units.*

3. Use D-Pad right [4] to begin value entry mode. The 

selected digit begins fl ashing, indicating that it is ready 

to be changed. Use D-Pad right [4] and left [3] to move 

between the digits.

4. Use D-Pad up [5] or down [6] to increase or decrease the 

selected digit.

5. To store your Height, press [SET] or [HEIGHT]. To confi rm 

the Height has been set, “Ht Set” is displayed for one second. 

*

In Imperial Mode, only the following units are available:

Feet-Inch, Feet and Inches.

In Metric Mode, only the following units are available: Meters, 

Centimeters and Millimeters.

Note: Press [HEIGHT] to view a stored Height. A Height is only 

cleared if a new Height is stored, an All Clear or Reset is performed, 

or if the unit is switched between Imperial and Metric Modes.

U

SER’S 

G

UIDE

 — 39