D-Link DI-206 User Manual - page 160
DI-206 ISDN Remote Router
148
PROM System
Configuration
•
Boot File Name – This specifies a complete path and filename on
the TFTP server. If you choose to use a configuration file, this setting
must show the path and filename to the configuration file. If you are
not using a configuration file, this must show the path and filename to
the software update image file.
•
Last Boot Server IP Address – This shows the last boot server
used to download an image file. This is for reference only.
•
Last IP Address – This shows the last IP address used for the
LAN interface. Again, this is for reference only. The LAN port must
have an IP address in order to access the TFTP server via the LAN
network.
•
Update Software from Configuration File – Either Yes or No. If
Yes, the software update procedure will try to access a configuration
file located at the path defined in the above Boot File Name. Please
ensure that the path and file name of the image file is listed in the
configuration file. If set to No, the update procedure will try to find
an image file at the Boot File Name path. Please see Appendix F,
“Configuration File” for more information about configuration
files.
After the parameters are set in the Software Update screen, SAVE
the changes, EXIT, and perform a System Reset or Execute Bootload
to begin the software download process.
After the new runtime software has been downloaded, the router will
automatically start up using the new software with the Software Update
Control setting Disabled to avoid a downloading loop.