D-Link DI-206 User Manual - page 44

DI-206 ISDN Remote Router

32

Configuration and

Management

•

  Global Reception – When this is enabled, the Phone 1 and Phone

2 jacks will receive all phone calls directed to them by the telephone

company’s switch. When disabled, the router will check incoming

calls to the Phone 1 and 2 jacks against the telephone numbers

specified in the A/B Adapter 1 and 2 fields above.

•

  Block Outgoing CLID – When this is enabled, your ISDN data

phone number and voice phone numbers will never be sent out when

trying to establish a connection. Thus, even if sites being called have

Caller ID, they still won’t be able to know your phone number.

•

  Inbound Authentication – This defines the authorization protocol

that will be used when accepting a dial-in connection. The choices

are Password Authentication Protocol [PAP], Challenge Handshake

Authentication Protocol [CHAP] or None. PAP and CHAP do not

provide a screen for users to manually enter their Username and

Password – instead, this data must be entered into the dialing

software before placing the call. Make sure the device dialing in is

using the same protocol as defined here. The None setting may be

used when you do not wish dial-in users or networks to identify

themselves or be subject to security.

•

  Call Bumping – This setting only takes effect when both B channels

are connected and using multi-link PPP. If this is the case and call

bumping is enabled, when you receive an outgoing voice call, the

second B channel will be dropped (with all traffic being moved to

the first B channel) and the voice call will be received. If disabled,

both B channels will continue their data transmissions uninterrupted

and the voice call will be ignored.

•

  State – Enables or disables the ISDN port.