EDAN iSE-301 User Manual - 4.2 Printing Ecg Reports
SE-301 Series Electrocardiograph User Manual Sampling and Printing ECG
- 21 -
4.1.2 Entering Patient Information by Acquiring Orders
NOTE: To use the order function, the data management software (DMS) of the
manufacturer must be installed in the PC.
Operation procedures are as follows:
1. Connect the electrocardiograph to the PC through the network.
2. Log into the DMS.
3. Set Remote IP, Local IP, Gateway and Subnet Mask in the Transmission Setup window.
4. Click the patient symbol on the main screen to open the patient information window, and then
click Order to open the Order screen.
5. Click Load to download order records from the server.
6. Select an order and click Examine to enter the presampling screen.
4.2 Printing ECG Reports
The operation procedure is as follows:
Manually switch lead group
MANU
mode
Configure printing and system
parameters if necessary
Select a work mode
Press PRINT/STOP to start
sampling
Press PRINT/STOP to stop
sampling
NOTE:
1. The printing mode cannot be changed during the printing course. Stop printing
reports before changing the printing mode.
2. In the MANU mode, press the 1mV/COPY key to print out 1mV mark in the ECG
report.S