EDAN iSE-301 User Manual - page 38

SE-301 Series Electrocardiograph User Manual                                        Settings 

- 32 - 

When it is set to On, the Minnesota Code will be printed in the ECG 

report. 

Device No. 

Choose from: On or Off 

When it is set to On, the Device No. will be printed in the ECG report. 

Baseline 

Adjustment 

Choose from: Horizontal, Auto or Off 

Select  Horizontal, the baselines of the lead groups are adjusted 

simultaneously, and the baselines of the leads in the same row are on the 

same line. 

Select Auto, the baselines of the lead groups are adjusted respectively. 

Select  Off, the baselines of the lead groups are adjusted equally in the 

ECG reports. 

Record Device   

Choose from: Thermal, 

HP 1010/1510/2010/1050/2000, 

HP 

M401/2015/2035/1525, HP1020/1020PLUS/1106, or HP 1505   

You should connect the corresponding USB printerto the 

electrocardiograph before printing with the selected record device. 

WARNING 

If the printer used is not the type listed above, additional safety 

measures (such as applying an isolation transformer to supply the 

medical system) should be taken when the safety of the medical 

system has not been evaluated. If in doubt, consult our technical 

service department or your local distributor. 

CAUTION 

It is forbidden to connect or disconnect an external memory or a 

USB printer during the transmission course. 

NOTE: 

1.  During the USB printing course, pressing the PRINT/STOP key 

again cannot stop printing ECG reports. 

2.  For details of the ECG report printed by the USB printer, please 

refer to section 4.3.2 "PDF Report". 

3.  USB printing is ineffective in the AUTO mode and RHYT mode. 

4.  Make sure that paper is installed in the USB printer before 

printing. Error may occur if no paper is loaded in the USB Printer.