EDAN iSE-301 User Manual - 6.3 Record Info Setup

SE-301 Series Electrocardiograph User Manual                                        Settings 

- 30 - 

Lowpass Filter 

The cutoff frequency can be set to 75Hz, 100Hz, 150Hz, 270Hz or 300Hz 

Lowpass Filterrestricts the bandwidth of input signals.   

All the input signals whose frequency is higher than the set cutoff frequency 

will be attenuated.   

NOTE:  Only when EMG Filter is set to Off, can the setting of 

Lowpass Filter be effective. 

NOTE: To pass the distortion test, the electrocardiograph has to be configured with the 

highest bandwidth in filter settings. Otherwise, ECG signal may be distorted. 

6.3 Record Info Setup   

6.3.1 Setup 1 

Item 

Description 

Print Out 

Choose from: On, Off   

Select Off to disable the print function in the AUTO or RHYT mode. 

Speed

Choose from: 5mm/s,  6.25mm/s,  10mm/s,  12.5mm/s,  25mm/s and 

50mm/s 

NOTE: The speed is corresponding with the work mode.

Gain 

Choose from: 1.25mm/mV, 2.5mm/mV,  5mm/mV,  10mm/mV, 

20mm/mV, 10/5mm/mV and 20/10mm/mV 

10/5mm/mV means that the gain of limb leads is set to 10mm/mV, while 

the gain of chest leads is set to 5mm/mV.

Auto Record Style  Choose from: 3×4, 3×4+1R, 1×12, 1×12+1R and 3×2+2×3 

Auto Record 

Sequence 

Choose from: Sequential or Synchronous 

Select  Sequential, the lead group is printed one by one in a certain 

sequence. The start time of a lead group is just the end time of the 

previous lead group. 

Select  Synchronous, the lead group is printed one by one in a certain 

sequence. All leads are printed with the same start time. 

AGC 

AGC means auto gain control.   

Choose from: On or Off 

Select  On,the gain can be automatically adjusted according to actual 

signals.