EDAN iSE-301 User Manual - 9.4 Care and Maintenance
SE-301 Series Electrocardiograph User Manual Cleaning, Care and Maintenance
- 44 -
1. Switch off the main unit and disconnect it from the power cord.
2. Wipe the exterior surface of the equipment using a soft cloth dampened with the disinfectant
solution.
3. Wipe off the disinfectant solution with a dry cloth after disinfection if necessary.
4. Dry the main unit for at least 30 minutes in a ventilated and cool place.
9.3.2 Disinfecting the Patient Cable
1. Wipe the patient cable with a soft cloth dampened with the disinfectant solution.
2. Wipe off the disinfectant solution with a dry cloth after disinfection.
3. Leave the patient cable to air dry for at least 30 minutes.
9.3.3 Disinfecting the Reusable Electrodes
1. Wipe the suction bulbs of chest electrodes and the clamps of limb electrodes with a soft cloth
dampened with the disinfectant solution.
2. Wipe off the disinfectant solution with a dry cloth after disinfection.
3. Leave the suction bulbs and clamps to air dry for at least 30 minutes.
9.4 Care and Maintenance
9.4.1 Recharge and Replacement of Battery
1) Capacity Identification
The battery capacity can be identified according to the battery symbol in the top right corner
of the LCD screen.
->
->
->
Capacity is from full to empty.
2) Recharge
SE-301 is equipped with the recharge control circuit together with the built-in rechargeable
lithium battery. When the unit is connected to the mains supply, the battery will be recharged
automatically. During the recharging course, the battery symbol flashes in the top right
corner of the LCD screen. When the battery capacity is full, the symbol stops flashing.
Because of the capacity consumption during the storage and transport course, the battery