EDAN iSE-301 User Manual - 6.5 Transmission Setup

SE-301 Series Electrocardiograph User Manual                                        Settings 

- 34 - 

6.5 Transmission Setup   

NOTE: 

1.  To transmit ECG data to the PC, the Smart ECG Viewer software produced of EDAN 

must be installed in the PC. You should log into the Smart ECG Viewer software 

before transmission. 

2.  If the power supply suddenly breakdown during data storage or transmission, file 

system error may occur. In this case, the file system should be formatted. 

Item 

Description 

Device No. 

Enter Device No., it should be within 7 ASCII characters.

Auto Transmission 

Choose from: On or Off 

Select On, ECG data will be transmitted automatically after an ECG 

report is printed out in the AUTO or RHYT mode. 

Transmission Mode 

Choose from: Ethernet or Wireless 

FTP Information 

Enter data in the FTP Path, FTP User Name textboxes. 

IP Addresses 

Set Server IP, Local IP, Set Gateway, Set Subnet Mask 

For details, please refer to Section 5.1: "Transmitting ECG Records to 

the PC". 

6.6 Lead Setup 

Item 

Description 

Rhythm 

Lead1/2/3

Choose from: І, П, III, aVR, aVL, aVF, V1, V2, V3, V4, V5, or V6,the default 

NOTE: Rhythm Lead 1/2/3 must be different from each other.

Lead 

Sequence 

Choose from: Standard or Cabrera 

Lead 

Sequence 

Lead group 

1 

Lead group 

2 

Lead group 

3 

Lead group 

4 

Standard 

І, II, III

aVR, aVL, 

aVF

V1, V2, V3

V4, V5, V6

Cabrera 

aVL, І, -aVR

II, aVF, III

V1, V2, V3

V4, V5, V6

Lead off hint  When it is set to On andlead off waves are detected in the presampled waves, a 

lead off hint message will be displayed.