Festool Domino Machine Instruction Manual - page 10
This first photo is looking at the front of
the Domino fence with the fence piece
raised to the zero degree angle for clarity
of view. The slot in the center towards
the bottom (red arrow) is where the cutter
emerges when the body is pushed to-
wards the work piece to make the mortise
cut.
The cutter centerline is 10mm up
from the base of the fence assembly
(green arrow above)
.
Two alignment pins are spring loaded and
are set 74mm apart so each is 37mm
from the centerline of the cutter.
The right and left spring loaded alignment
pins are shown in detail below. The right
pin is mounted in an eccentric with a
screwdriver slot by which you can turn
the eccentric to bring the two pins into
exact alignment the same distance
from the vertical centerline of the
cutter. The left pin is fixed in posi-
tion 37mm from the vertical center-
line of the cutter and 24mm from the
outside of the pin to the outside
edge of the fixed portion (base) of
the fence (blue arrow).
The pins are 5mm in diameter so
the base is machined to be 132mm
wide or 66mm from outside edge to
vertical center of cutter. All of these
measurements are very useful to
keep in mind as they each can play
a role in helping you precisely posi-
tion the center of the Domino mor-
tise slots.
When you first get your machine, make
sure the adjustable fence height pointer is
exactly on 10mm when the fence is on
the stop block marked 20mm, the angle
pointer is exactly on mark, and the dis-
tance between the two spring loaded pins
is 74mm. Adjust the right pin shown be-
low if necessary.