Festool Domino Machine Instruction Manual - page 41

photos below.  Here is the locating of the 

leg stretcher mortises.  With both sides of 

the leg curved you need the cut off piece 

to get a reference.  Be sure to align the 

cut off pieces in the same place up and 

down on the leg so the relative saw kerf 

is the same on all four legs.

While I did not need it here, use 

of the auxiliary fence would pro-

vide more stability for the Dom-

ino machine for cuts such as 

these.

Next comes the cutting of the 

Domino mortises in the ends of 

the frame members.  The front 

and back members are cut hori-

zontally by use of the saddle 

fence shown here and on the next 

page. 

The mortises cut in the front and back 

upper and lower  members are not cut 

in the center of the 50mm dimension.  

Instead they are offset a bit so their 

edges will line up properly with the side