Festool Domino Machine Instruction Manual - page 9
The stop block is marked to center the
bit on work pieces 16, 20, 22, 25, 28, 36
and 40mm thick.
You can also simply use the height
scale to set the fence any distance you
want it to be above the horizontal cen-
terline of the bit within the range of 7mm
to 30mm.
The minimum height of 7mm ensures
that a 10mm cutter will leave a minimum
of 2mm of wall between the upper side
of the mortise slot and the upper side of
the work piece so you don’t inadvertently
drive the cutter into the bottom side of the
fence.
The fence also rotates from 90 degrees
angle relative to the edge of the work
piece (meaning the fence is parallel with
the cutter) to zero degrees relative to the
edge of the work piece (meaning the cut-
ter is moving perpendicular to the fence
the way it is shown in the photo left).
Ball detent stops are also provided for
common in-
termediate
settings, or
you can sim-
ply set the
angle with the
protractor
scale and
pointer. The
pointer is ad-
justable so
you can cali-
brate the an-
gles to be
dead on.
Now let’s look
at the variety
of alignment
marks to help
you place the
mortise slots
exactly where
you want
them.