Festool Domino Machine Instruction Manual - page 44
The first thing to do is assemble the two
sides after cutting the groove for the burl
side panels. These photos show this se-
quence.
Once the sides are glued up and squared
with the leg stretchers in place, we can
turn our attention to building the back rail,
stile and burl panel and the two front
doors.
In the photo above
notice how handy the
Festool DX 93 E de-
tail sander is for
reaching into tight
spots such as where
the leg stretchers
meet the legs. Any
glue squeeze out on
purple heart really
shows once the finish
goes on so be sure to
sand very throughly.
The photo above
shows a booboo.
When I first started this
piece I thought it would
look good with a book
matched maple top.
You can see the glue
up here. But, once the
piece was completed it
became clear that a
maple top was “over
the top” so I crafted the
purple heart top you
see in the final piece.