KEB COMBIVERT F6 Instructions For Use Manual - page 40
4.1 System variations
The cabinet system is available in different variations which can be combined. The base
system always serves as basis.
4.1.1 basic system
• Circuit breaker with motor drive
• Varistors
•
HF filter
•
AFE filter
• Drive converter
• Motor connection terminals
• LW heat exchanger
• Liquid distributors
• Control elements (HMI, DEIF I / O outputs, STO, 24V DC supply, PLC control, bus
system)
4.1.2
Basic system with additional sinusoidal output filter
The basic system is extended by an additional 600 mm TS8 control cabinet, which
contains the sinus output filter. Optionally, braking resistors can be installed above the
sine output filter.
4.1.3 Accessories and options
The cabinet system can be ordered in different variants. There are several options that
extend the scope of functions. These options are factory-integrated when ordering and
will be taken into consideration in the control cabinet documentation, however they
may cause a change of the dimensions.
basic system with additional connection cabinet
The basic system is extended by an additional 200 mm TS8 control cabinet, which offers
the possibility to insert and connect the supply lines (L1 / L2 / L3) from above.
basic system with main switch and NH fuse
The basic system is extended by an additional 400 mm TS8 control cabinet. Instead of
the circuit breaker, there is a contactor, e.g. DIL 1000. The additional control cabinet is
equipped with a mechanical main switch, NH fuses, as well as the mains connections.
basic system with Dc-busbar
It is possible to install a DC-busbar with DC fuses above the cabinet system in order to
connect additional components. This should be designed and configured together with
KEB.
40
OVErVIEW cAbINET SYSTEM