Lancia THESIS CONNECT Owner's Handbook Manual - 167
167
This control is accepted by CON-
NECT only if:
– outside temperature lower than 20
°C
– coolant temperature lower than 50
°C
– the ignition key is at STOP or re-
moved
– car battery charged
– sufficient fuel level
– the timer is deactivated.
Switching the heater on
To switch the heater on, press the
remote control button ON for 1 or 2
seconds, while keeping the antenna in
vertical position; the positive or un-
successful activation is indicated by
the remote control red led B in the fol-
lowing way:
– the led turns on for about 2 sec-
onds = the signal has been correctly
received and the heater has been ac-
tivated
– the led flashes for about 2 seconds
= the signal has not been received.
In the latter case you are advised to
move before trying to activate it by
pressing again the ON button.
After the confirmation activation,
the led B will flash every 2 seconds for
the whole operation cycle duration.
IMPORTANT If led B turns on with
green colour, press twice both remote
control buttons ON and OFF within 1
second to set the red colour.
Activation length
When pressing the remote control
button ON the last recorded activa-
tion length is always activated.
To see the recorded length, press at
the same time for three consecutive
times within 1 second, the remote
control buttons ON and OFF, count
the number of flashes of led B then
compare them to those shown in the
table below, including also the first
flash appearing the third time you
press the buttons.
Default activation length is 30 min-
utes but it can be changed through
the following procedure:
– press at the same time for three
consecutive times within 1 second, the
remote control buttons ON and OFF
– count the number of flashes of led
B including also the first flash ap-
pearing the third time you press but-
tons ON and OFF
– press OFF to set the length suc-
cessive to the set one (press OFF for
several times to set the required
length in sequence)
– wait for about 10 seconds for timer
storing.