Lancia THESIS CONNECT Owner's Handbook Manual - 280
280
Bolt tightening torque
must be 98 Nm (10 kgm).
After replacing the
wheel, you are advised to have
the wheel bolt tightening checked
at a Lancia Dealership as soon as
possible.
Insufficient tightening could
actually make the wheel bolts
loosen too much, with clearly
dangerous consequences. If the
bolts are tightened too much, they
could be damaged and their
resistance might be compro-
mised.
23) Place the removed wheel, the
jack and the tools in the boot and
fasten appropriately.
IMPORTANT Put the jack back
into B (fig. 8) and clamp it by
screwing handle A (fig. 8) manually
in order to prevent vibrations during
travelling.
fig. 19
L0A0045b
fig. 20
L0A0365b
fig. 21
L0A6027b
21) Tighten up the wheel bolts in a
criss-cross fashion, following the
sequence shown:
- fig. 19 = versions with alloy rims
- fig. 20 = versions with steel rims.
22) On versions with alloy rims,
refit the wheel hub cap pressing it
slightly. On versions with steel rims,
approach the wheel cap making the
inflating valve A (fig. 21) coincide
with flaring B. Press the cap circum-
ference starting near the inflating
valve and proceeding until fitting
the cap completely.
IMPORTANT The wheel hub cap
(alloy rims) or the wheel cap (steel
rims) may fly off when the car is
moving if it is not fastened correctly.