Lancia THESIS CONNECT Owner's Handbook Manual - page 88

87

fig. 84

L0A0420b

fig. 85

L0A0255b

For proper mounting, proceed as

follows:

– remove the upper tether on the

back of the child's restraint system;

– check whether the release lever B

(fig. 83) is at rest position (inward);

– identify the brackets A (fig. 83)

and mount the child restraint system

with the retainers C (fig. 83) aligned

to the brackets;

– push the child restraint system

until hearing the locking clicks;

– check for proper locking by mov-

ing the child's seat with force: the

built-in safety mechanism actually

inhibit improper coupling with just

one coupling locked;

– fit the supporting foot into sup-

port B (fig. 84), secured on the

child's seat back; to do this, pull

knob A (fig. 84) outwards, fit the

foot into the support, release knob A

and push the foot upwards until the

locking pin clicks;

– fully loosen knob C (fig. 84) and

extend both support legs until they

rest on the car floor; tighten knob C

in one of the preset holes.

Group 1

When the child grows up and

reaches the next weight group

(group 1, 9 to 18 kg), the child

restraint system should be rein-

stalled facing forward; keep to the

instructions provided by the child

restraint system manufacturer.