Lancia THESIS CONNECT Owner's Handbook Manual - 195
195
Turn ring B to position (+) to set
the speed reached or to increase the
stored speed.
Turn ring B to position (–) to
decrease the stored speed.
The speed will be increased or
decreased by approximately 1 km/h
each time ring B is operated. Hold
the ring turned to set the speed con-
tinuously. The new set speed will be
automatically kept.
Button C (RCL) allows to reset the
stored speed.
IMPORTANT Turn the ignition
key to STOP or switch A to OFF to
delete the stored speed and switch
the system off.
Storing the speed
Move switch A to ON and take the
car to the required speed normally.
Turn ring B to (+) for at least three
seconds and release it. The car speed
will be stored and you can now
release your foot from the accelera-
tor.
The car will continue at the con-
stant speed until one of the following
events occur:
– the brake pedal is pressed
– the clutch pedal is pressed
– the automatic gear lever is unin-
tentionally shifted to N.
IMPORTANT If required (e.g. for
overtaking) you can accelerate sim-
ply by pressing the accelerator. The
car will return to the previously set
speed when the accelerator pedal is
released.
Resetting the stored speed
To reset the stored speed after
switching the device off, e.g. by
pressing the brake or the clutch ped-
als:
– accelerate progressively to reach
a speed which is close to the previ-
ously set speed
– engage the gear which was
engaged when the speed was set (4
th
,
5
th
or 6th gear)
– press button C (RCL).
Increasing the stored speed
The stored speed can be increased
in two ways:
– by pressing the accelerator pedal
and storing the new speed (turning
ring B for longer than three seconds)